Installation Instructions

GTN 6XX/7XX AML STC Installation Manual 190-01007-A3
Page 3-22 Rev. 4
Complete the following steps to assemble the backshell onto the connector:
1. Attach the Shield Block (2) to the backshell (1) by inserting the flathead screws (3) through the
holes on the Shield Block and threading into the tapped holes on the backshell (1)
(See Figure 3-2).
2. Wrap the cable bundle with Silicone Fusion Tape (19 or a similar version) at the point where the
backshell strain relief and cast housing will contact the cable bundle.
3. Place the smooth side of the backshell strain relief (7) across the cable bundle and secure using
the three screws (6). Ensure that each half of the strain relief bar is supporting half of the cable
bundle.
CAUTION
Placing the grooved side of the strain relief across the cable bundle may damage wires.
4. For P1001, install the configuration module into the connector backshell. Refer to Section 3.6.3.2
for instructions on installing the configuration module into the backshell.
5. Attach the cover (8) to the backshell using two screws (9).
NOTE
Each tapped hole on the shield block (2) may accommodate only three ring terminals
(15). Two wires per ring terminal will necessitate the use of a ring terminal, #8,
insulated, 14-16 AWG (MS25036-153). Each hole in the shield block can accommodate
six shield drains.
6. Install ring terminals (15) onto the wires (13), grouping wires as appropriate for the connector.
7. Terminate the ring terminals to the shield block (2) by placing items on the pan head screw (16)
in the following order: split washer (17), flat washer (18), first ring terminal, second ring terminal
if needed, before finally inserting the screw into the tapped holes on the shield block.
8. Insert the assembled connector into the backplate. Using screws (6), secure the connector into the
backplate.