Installation Instructions

190-01007-A3 GTN 6XX/7XX AML STC Installation Manual
Rev. 4 Page 3-23
3.6.3.2 Configuration Module Installation (P1001 only)
GTN P1001 connector assemblies serve as the housing for a configuration module. This sections lists
configuration module assemblies for new and existing GTN installations.
Table 3-10. Configuration Module Wire Color Reference Chart
Color Function P1001 Contact
Red Vcc 65
Black Ground 64
Yellow Data 62
White Clock 63
NOTE
The pin contacts supplied with the GTN configuration module are specifically
made to accommodate 28 AWG wire. The crimp tool should have the indenter
set to the correct setting when crimping these contacts to the configuration
module harness.
3.6.3.2.1 Configuration Module Assembly with Potted PCB (new installations)
Refer to Figure 3-6 for details and item numbers referenced in the following procedure.
1. Strip 0.17” of insulation from each wire prior to crimping.
2. Crimp pins (4) onto each wire of the four-conductor wire harness (3).
5. Insert the newly crimped pins and wires (3, 4) into the appropriate connector housing (5)
locations shown in Figure 3-6 and Figure E-4.
6. Plug the four-conductor wire harness (3) into the connector on the PCB (1).
7. Insert the PCB (1) into the backshell (6) recess.
8. Attach cover (7) to backshell (6) using screws (8).
Table 3-11. Configuration Module Kit 011-00979-03 (P1001)
Figure 3-6
Reference
Description Garmin P/N
1 Configuration Module, PCB Board Assembly w/EEPROM 011-02178-00
3 4-Conductor Harness 325-00122-00
4 Pin Contact, Crimp, #22D 336-00021-00