Installation Instructions

190-01007-A3 GTN 6XX/7XX AML STC Installation Manual
Rev. 4 Page 3-25
3.6.3.2.2 Configuration Module Assembly with Spacer (existing installations)
NOTE
Configuration module assembly P/N 011-00979-00 may not be available for
new GTN installations. For new GTN installations, refer to Section 3.6.3.2.1.
Table 3-12. Configuration Module Kit 011-00979-00 (P1001)
Figure 3-7
Reference
Description Garmin P/N
1 Configuration Module, PCB Board Assembly w/EEPROM 012-00605-00
2 Spacer, Configuration Module 213-00043-00
3 4-Conductor Harness 325-00122-00
4 Pin Contact, Crimp, #22D 336-00021-00
Refer to Figure 3-7 for details and item numbers referenced in the following procedure.
1. Strip 0.17” of insulation from each wire prior to crimping.
2. Crimp socket contacts (4) onto each wire of the four-conductor wire harness (3).
3. Insert newly crimped socket contacts and wires (3, 4) into the appropriate connector housing
location shown in Figure 3-7 and Figure E-4.
4. Apply the spacer (2) by wrapping it around the PCB board (1) making sure to insert the plastic
connector mounted on the board into the hole provided in the spacer.
5. Plug the four-conductor wire harness (3) into the connector on the PCB board (1).
6. With pad (2) in position, insert PCB board (1) into the backshell recess.
7. Orient the connector housing so that the inserted four conductor wire harness (3) is on the same
side of the backshell as the inserted PCB board (1).