Installation Instructions

190-01007-A3 GTN 6XX/7XX AML STC Installation Manual
Rev. 4 Page 5-1
5 SYSTEM CONFIGURATION AND CHECKOUT
5.1 System Configuration Overview
This section contains instructions for configuring the GTN for each installation as well as checks to
ensure the system is properly installed and functioning correctly. The steps that are not applicable to a
particular installation may be skipped. A checkout log that is included in Table 5-66 at the end of this
section should be filled out during the checkout procedures. The completed checkout log sheet should be
maintained with the aircraft permanent records to document the configuration of this installation. A
summary of the steps required for configuration and checkout of the GTN is as follows:
• Perform installation checks (Sections 5.2 and 5.3)
• Load software into the GTN (if required) (Section 5.4.1)
• Load software into interfacing LRUs if required (Section 5.4.2 through 5.4.5)
• Configure the GTN for the specific installation (Sections 5.5)
• Perform ground checks to verify the interfaces to external sensors (Sections 5.7 and 5.8)
• Perform the specified flight checks (Section 5.8)
• Complete the checkout log (Section 5.10.3)
• Update the aircraft documentation (Section 5.10)
NOTE
Throughout the next section, many screenshots and examples are used to illustrate the
software loading and configuration and checkout process. Every effort has been made to
ensure the accuracy of these examples; however, changes may occur that result in the
examples being out of date. Always refer to the Equipment List (005-00533-C1) for the
correct software versions and part numbers.
NOTE
Throughout the next section, many screenshots are shown of the GTN 7XX. The
procedures and methods for accessing pages on the GTN 6XX are similar to what is
described for the GTN 7XX, unless specifically noted.