Installation Instructions

GTN 6XX/7XX AML STC Installation Manual 190-01007-A3
Page 5-4 Rev. 4
5.4.1 GTN Software Loading
1. Remove power from the GTN by opening the circuit breaker.
2. Insert the correct GTN Software Loader Card into the SD card slot. See Section 2.3.3 for
instructions on how to create a loader card.
3. Restore power to the GTN by closing the circuit breaker.
4. The Configuration Mode home page, shown in Figure 5-1,should now be displayed. Touch
Updates to display the software updates that are available.
5. Verify that the software version being loaded to the GTN matches the software version listed on
the GTN STC Equipment List, 005-00533-C1. See Figure 5-3. The updates page displays the
version that is installed on the unit and the version installed on the loader card.
6. Verify that the available GTN software updates are being displayed by ensuring that ‘GTN
Software Updates’ is displayed on the key in the upper left corner of the display.
7. To update the GTN with all software available, touch Select All.
8. To begin the software update, touch Update on the bottom of the display.
9. The GTN will display the prompt, ‘Start GTN Software Updates?’.
10. Touch OK to allow the GTN to go through the update process.
11. When the updates are finished, the GTN will display ‘Update Complete!’. When finished, remove
power from the GTN and remove the Software Loader Card. Reinsert the database card into the
SD card slot.
Figure 5-1. Configuration Mode
Figure 5-2. Updates Page