Installation Instructions

190-01007-A3 GTN 6XX/7XX AML STC Installation Manual
Rev. 4 Page 5-43
5.5.4.2 Stormscope Configuration
NOTE
The Stormscope pages are only available if the WX-500 is connected to the RS-232
channel that is configured for the WX-500.
Select the Stormscope configuration page from the External Systems page, shown in Figure 5-26. The L-3
Communications WX-500 Stormscope configuration is reported by the WX-500 through RS-232 data.
To display the Stormscope configuration information, touch the Configure key. Verify the Status field
indicates ‘OK’, and that the other displayed parameters are correct based upon the installation. See the
configuration information in the WX-500 Installation Manual to determine the correct configuration.
When a GTN is interfaced with a WX-500 Stormscope, the ‘Synchro’ or ‘Serial’ heading formats may be
used. If another heading format is used, lightning strike information is visible on the Weather Page, but
not the Map Page.
Figure 5-27. Stormscope Page
Figure 5-28. Stormscope
Configuration Page