Installation Instructions

GTN 6XX/7XX AML STC Installation Manual 190-01007-A3
Page 5-44 Rev. 4
5.5.4.3 Stormscope Test Page
To access the Stormscope Test page, shown in Figure 5-29,
select the Stormscope Test key from the Stormscope page,
shown in Figure 5-27 above. This page shows current strike
activity, WX-500 status, and the heading supplied by the
WX-500. The WX-500 mode may be changed to Cell, Strike,
Noise, Strike Test, Self Test, and Demo.
The strikes can be cleared from the display by touching the
Clear Strikes key. The view can be changed by touching
either the 360˚ key or the Arc key.
Verify that the WX-500 mode can be changed. Refer to the
WX-500 manual for specific installation test procedures for
the WX-500, using this page to view strike data, change the
WX-500 mode, view WX-500 status, trigger count, and
heading.
5.5.4.4 Stormscope Download Data Page
Select the Download Data key from the Stormscope page.
This page shows raw data downloadable from the WX-500.
Optional sets of data include WX-500 software version,
configuration data, environment data, and fault log data.
Verify that the configuration data is correct as intended. To request which packet of data to display, touch
the key underneath ‘Data to Display’ and select a data type from the menu.
5.5.4.5 Traffic Test Page
NOTE
The following pages are only available if one of the ARINC 429 or RS-232 inputs is
configured for a traffic format.
The Traffic Test page displays the traffic system modes of
operation and current traffic situation.
Depending on the type of traffic system installed, the
information displayed on the traffic test page can vary.
Figure 5-29. Stormscope
Test Page
Figure 5-30. Traffic Test Page