Installation Instructions

190-01007-A3 GTN 6XX/7XX AML STC Installation Manual
Rev. 4 Page 5-47
5.5.4.7.1 Transponder Inputs and Outputs
Access the transponder inputs and outputs page, shown in Figure 5-33 by touching the Inputs and Outputs
key from the Remote XPDR configuration page. The transponder RS-232 channel inputs can be
configured by the GTN. RS-232 channel 1 input for the transponder can only be set to Remote, and is the
default for channel 1 input. RS-232 channel 1 is used for control and remote configuring of the
transponder.
5.5.4.7.1.1 RS-232 Configuration
The following outlines RS-232 channel settings and describes what each setting is used for. Select the
correct input/output setting based upon the installed interfaced equipment. It is not necessary to select the
baud rate for the transponder port to which the GTN is connected.
Figure 5-32. Remote XPDR
Configuration Page
Figure 5-33. Remote XPDR
Inputs/Outputs Page
Table 5-36. RS-232 Channel 1 Inputs
Selection Description
Remote The RS-232 port is configured for remote control by the GTN.
Table 5-37. RS-232 Channel 1 Outputs
Selection Description
Remote RS-232 serial output remote data.
Remote + TIS RS-232 serial output remote data with TIS.