Installation Instructions

GTN 6XX/7XX AML STC Installation Manual 190-01007-A3
Page 5-60 Rev. 4
5.5.4.8.2 GMA 35 Audio Panel Settings
NOTE
When configuring volumes and squelches, keys can be touched and held to scroll
quickly through values.
To configure the audio panel, go to the External Systems page
and touch the Audio Panel key to display the audio panel
configuration page shown in Figure 5-36. On the main audio
panel configuration page, there are two keys labeled
Configure and Connected Radios. Touch the Configure key
to access configuration settings for audio routing, volume, and
miscellaneous options. The ‘Connected Radios’ menu allows
the radios that are connected to the audio panel to be
configured.
For GTN software version 2.00, under the configure page,
touch the Set to Default Config key prior to configuring the
GMA 35. This will command the audio panel settings to the
factory default configuration. This key must be touched prior
to GMA 35 configuration. Touch OK to acknowledge the
prompt shown in Figure 5-36.
For GTN software version 3.00 or later, it is not necessary to
set the GMA 35 settings to default prior to configuration.
Figure 5-36. Audio Panel
Configuration Page