Installation Instructions

GTN 6XX/7XX AML STC Installation Manual 190-01007-A3
Page 1-2 Rev. 4
1.3 Scope
This installation manual applies to the modification of an aircraft under AML STC SA02019SE-D to
install the equipment described in Table 1-1. Interfaces between the equipment listed in the second
column and the GTN and/or GMA 35 are covered by STC SA02019SE-D.
Table 1-1. Scope of STC SA02019SE-D
Equipment Installation Covered by STC
SA02019SE-D
Equipment Installation NOT Covered by STC
SA02019SE-D
• GTN 625
• GTN 635
• GTN 650
• GTN 725
• GTN 750
• GMA 35
• NAV Antenna Cable Splitter
• NAV Antenna Cable Diplexer
• Equipment necessary to support
installation of the equipment above, such
as the installation kit accessories
(Section 2.3.1) and the wiring and circuit
breakers shown in Appendix E and
Appendix F.
• GPS/SBAS Antenna(s)
• VHF COM Antenna(s)
• VHF NAV Antenna(s)
• Marker Beacon Antenna
• Equipment listed in Appendix C (except
those listed in the left column of this table)
• Equipment listed in Appendix D (except
those listed in the left column of this table)
This STC approves the interface to the equipment listed in Appendices C and D. However, this STC
assumes that these devices are existing. Additional airworthiness approval beyond this STC will be
required to install these devices.
This STC is applicable for implementation in Part 23 aircraft that are on the Approved Model List (AML).
Only the equipment and systems interfaces described in this manual have been determined to be mutually
compatible and operationally suitable; these are approved for use as characterized herein.