Installation Instructions

GTN 6XX/7XX AML STC Installation Manual 190-01007-A3
Page E-44 Rev. 4
1. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE SPECIFIED.
2. GROUND DESIGNATIONS:
SHIELD BLOCK GROUND AIRFRAME GROUND
3. AT THE GTN 6XX/7XX, CONNECT SHIELD GROUNDS TO THE CONNECTOR BACKSHELL --
THE
SHIELD LEADS MUST BE LESS THAN 3.0". CONNECT THE SHIELD GROUNDS AT THE GDL
69/
69A
TO ITS CONNECTOR BACKSHELL IN ACCORDANCE WITH THE GDL 69/69A INSTALLATION
INSTRUCTIONS.
4. ANY ETHERNET PORT MAY BE USED IN LIEU OF ETHERNET PORT 3. IF THERE ARE NO FREE
PORTS ON THE GTN 6XX/7XX, THE OTHER LRU CAN BE DISCONNECTED FROM THE GTN 6XX
/
7XX AND THE GDL
69/69A CAN BE CONNECTED TO THE GTN 6
XX/
7XX IN ITS PLACE. THE
DISCONNECTED LRU CAN BE CONNECTED TO ETHERNET PORT 2, 3,
OR
4 ON THE GDL 69/69A.
5. USE AIRCRAFT GRADE CATEGORY
5 ETHERNET CABLE
. THESE INCLUDE THE FOLLOWING:
P1002
GTN 6XX/7XX
GDL
69
/69
A
24
25
24
23
26 22
2523
P691
s
6. ETHERNET PORTS 2, 3
,
OR 4
MAY BE USED LIEU OF PORT 1. THE PORT THAT IS USED MUST
BE ENABLED IN CONFIGURATION MODE. REFER TO THE GDL 69/69A INSTALLATION MANUAL
FOR ADDITIONAL DETAILS.
7. IN DUAL GTN INSTALLATIONS, GDL 69 DATA WILL BE FORWARDED TO THE OTHER GTN VIA
HSDB.
5
4
ETHERNET IN 3
A
ETHERNET OUT 3A
6
s
s
P/N
10424
(24 AWG
)
392404 (
24 AWG)
ETHERNET IN 3B
ETHERNET OUT 3B
CM GROUND
CM POWER OUT
CM DATA
CM CLOCK
GDL 69/69A
CONFIGURATION
MODULE
BLK
RED
YEL
WHT
21
40
60
1
ETHERNET OUT 1A
ETHERNET IN
1A
ETHERNET OUT 1
B
ETHERNET IN 1B
7
MANUFACTURER
PIC WIRE AND CABLE
CARLISLEIT
Figure E-17. GTN 6XX/7XX – GDL 69/69A Interconnect