Installation Instructions

GTN 6XX/7XX AML STC Installation Manual 190-01007-A3
Page 2-8 Rev. 4
2.3.2.7 Materials Required for Some GTN 650/750 NAV Antenna Installations
Some aircraft may require the use of a splitter or diplexer for connection of the VOR/LOC and G/S
antennas, or combination VOR/LOC/GS antennas. Refer to Figure E-18 to determine if a splitter or
diplexer is required for the installation.
• Garmin Part Number 013-00112-00 (Mini-Circuits ZFSC-2-1B+BNC.)
• Comant Diplexer VOR/GS, Model CI-507.
2.3.3 GTN Software Loader Card
A GTN Software Loader card may be created using a GTN Downloadable Software SD Card
P/N 010-01000-00 in conjunction with a GTN software application downloaded from the
Dealer
Resource Center on Garmin’s website. As an alternative, a pre-programmed software loader card may be
purchased from Garmin. Refer to the Equipment List (005-00533-C1) for the correct part number of the
pre-programmed GTN Software Loader Card.
NOTE
The downloadable application to create the GTN Software Loader Card only runs on
Windows PCs (Windows 2000, XP, Vista, and Windows 7 are supported). There is no
Mac support at this time.
NOTE
An SD card reader is needed to create the GTN Software Loader Card using the
application that is downloaded from Garmin. The approved readers are SanDisk
SDDR-99 and SDDR-93, although other SD card readers will work.
Create a GTN Software Loader Card as follows:
1. Go to the
Dealer Resource Center on Garmin’s website.
2. Download the GTN Software Loader Image. Refer to the Equipment List (P/N 005-00533-C1) for the
correct Software Loader Image part number.
3. Ensure that you have an SD card reader connected to the PC. Insert the GTN Downloadable Software
SD Card P/N 010-01000-00 into the card reader.
4. Run the executable file. The window shown in Figure 2-1 will appear.
Figure 2-1. GTN Software Updater Installation