Installation Instructions

GTN 6XX/7XX AML STC Installation Manual 190-01007-A3
Page 3-16 Rev. 4
Table 3-9. GMA 35 Backshell Assembly
Figure 3-2 thru
Figure 3-5 Ref
Description Garmin P/N Notes
1 Backshell 125-00083-00 [2]
2 Shield block 117-00147-00 [3]
3 Screw, 4-40x.250, FLHP 100, SS/P 211-63234-08 [3]
6 Screw, 4-40x.437, FLHP100, SS/P, Nylon 211-60234-11 [2]
7 Strain Relief 115-00499-02 [2]
8 Cover 115-00500-02 [2]
9 Screw, 4-40x.187, FLHP100, SS/P, w/Nylon 211-63234-06 [2]
10 Connector, D-Sub, HD, 44 Pin 330-00185-44 [4]
11 Multiple Conductor Shielded Cable As Required [5]
12 Shield Terminator As Required [5], [6]
13 Wire, Insulated (20-22 AWG), 3” max length As Required [5], [6]
14 Pin Contacts, #22D 336-00021-00 [4]
15 Ring terminal, #8, insulated, 18-22 AWG, MS25036-149 [5], [7]
16 Screw, PHP, 8-32x.312", Stainless or Cad Plated MS51957-42, [5], [7]
17 Split Washer, #8, (.045" compressed thickness) MS35338-137 [5], [7]
18 Flat Washer, #8, .032" thick, .174"ID, .375" OD,
Stainless or Cad Plated Steel
NAS1149CN832R,
NAS1149FN832P
[5], [7]
19 Silicon Fusion Tape 249-00114-00 [5]
[1] All items are applicable to P3501 and P3502 unless otherwise specified.
[2] Supplied as part of Backshell Kit P/N 011-00950-02 (P3501 and P3502).
[3] Supplied as part of Ground Adapter Kit P/N 011-01169-00 (P3501 and P3502)
[4] Supplied as part of GMA 35 Connector Kit P/N 011-02302-00
[5] Not supplied – must be purchased separately.
[6] Solder sleeve with pre-installed braid strap may be used instead of items 12 and 13.
[7] Not a Garmin part number.