Installation Instructions

GTN 6XX/7XX AML STC Installation Manual 190-01007-A3
Page 5-14 Rev. 4
NOTE
Refer to Appendix C for approved third party equipment interfaces to the GTN. If the
equipment and interface selections described below are not listed in Appendix C, other
FAA approval is required for that interface.
Table 5-5. RS-232 Channel Input Selections
Selection
GNS
Equivalent
Description Notes
Off Off No unit(s) connected to input of this channel.
Airdata
Format 1
Shadin-adc
Serial air data information from the following units:
• Shadin ADC 200/2000
[1]
Altitude
Format 1
Icarus-alt
Serial altitude data from the following units:
• Icarus Instruments 3000
• Sandia SAE5-35
• Garmin GTX 327 Transponder
• Trans-Cal Industries IA-RS232-X, SSD120
• ACK Technologies A-30 (Mod 8 and above)
[1]
Altitude
Format 3
Shadin-alt
Serial altitude data from the following units:
• Shadin 8800T, 9000T, 9200T
[1]
FADC
Format 1
Shadin-
FADC
Serial air data and fuel flow information from the following units:
• INSIGHT TAS 1000 Air Data Computer
[2]
Fuel
Format 1
Arnav/ei-
fuel
Serial fuel flow information from the following units:
• ARNAV FC-10, FT-10
• Electronics International FP-5L
[1]
Fuel
Format 2
Shadin-fuel
Serial fuel flow information from the following units:
• Shadin 91053XP, 91204XT(38)D, 91053, 912802-( ) Digital
Fuel Management System
•
JP Instruments EDM-700 Engine Monitor
[1]
GMA
Format 1
N/A This input format supports the GMA 35 audio panel interface. [3]
GMA
Format 2
N/A This interface is not used in this STC. [7]
GNS
Crossfill
N/A
Select this format to transmit flight plan information automatically to
a connected GNS 400W/500W navigator.
[7] [8]
GSR
Format 1
N/A
Select this format for the Garmin GSR 56.
[6] [7]
GTX Mode
C #1
N/A
Select this format for the GTX 32/327 transponder #1. Provides
status data, and flight ID. Choosing this input setting will
automatically configure the corresponding channel output to the
same setting.
[4]