Instruction Manual
Table Of Contents
- Important Safety Information
- Tools Needed
- Mounting Considerations
- Installing the Transducer on the Perspective Mode Mount
- Installing the Transducer on a Trolling Motor Barrel
- Installing the Transducer on the Trolling Motor Shaft
- Installing the Transducer on a Pole
- Installing the Transducer Using Low Profile Mounting Hardware
- Mounting the GLS 10 Black Box Device
- Transducer Settings and Operation
- Specifications
Viewing Modes
Using the perspective mode mount and extension arm, you can change the orientation angle of the transducer
between three sonar views.
When installing the transducer using the recommended adjustment knobs, no tools are necessary to change the
orientation between these three fields of view. You must loosen the knobs to change the orientation of the arm
and transducer, and tighten them to set the orientation.
You can verify the sonar view using the notches on the perspective mount bracket, the shaft mount, and the
transducer.
NOTE: The notches are not labeled on the transducer hardware, so you can use these tables and diagrams to
understand the positioning of the transducer and perspective view bracket when changing between sonar
views.
A and 1 Port downward view
A and 2 Port forward view
B and 3 Perspective view
C and 4 Starboard forward view
C and 5 Starboard downward view
6