System Maintenance Manual

Page 3-24 G1000 / GFC 700 System Maintenance Manual - 200/B200 Series King Air
Revision 6 190-00915-01
3.10 TAWS-A Support Configuration
This section applies only to installations with the TAWS-A option. The procedures outlined in this
section must be followed to load the necessary configuration files required to enable TAWS-A gear and
flap messages.
A TAWS-A enable card is also required for this option (see Section 3.31.)
1. With the loader card in the top slot of PFD1 and PFD1 in configuration mode, select the “SYSTEM
UPLOAD” page using the small FMS knob on PFD1.
2. Activate cursor and rotate the small FMS knob to display drop down menu. Highlight King Air - Options
and press ENT key on PFD1.
3. Rotate the small FMS knob to select “TAWS-A Support”. Press ENT key on PFD1.
4. Verify the “TAWS-A Support” is displayed in the “Item” window. Press “LOAD”.
Figure 3-21, TAWS-A Support Configuration
5. Monitor load progress. Verify software load completes without errors as indicated by the following:
• Green “PASS” in Configuration column for ALERTS.
• “Upload Complete………….COMPLETE” in the summary box.
6. Press ENT key on PFD1 to acknowledge upload complete.
7. Deactivate cursor.