Cockpit Reference Guide

Garmin G1000 Cockpit Reference Guide for the Beechcraft 300/B300 Series
190-01344-00 Rev. B 5
Nav/Com/XPDR/Audio Panel
Flight
Instruments
Nav/Com/
XPDR/Audio AFCS GPS Nav
Flight
Planning Procedures
Hazard
Avoidance
Additional
Features Annun/Alerts Appendix Index
NAV/COM/TRANSPONDER/AUDIO PANEL
ADF TUNING (OPTIONAL)
Tune the ADF using the remote ADF control head.
DME TUNING
1) Press the DME Softkey.
2) Turn the large FMS to select the DME source field.
3) Turn the small FMS Knob to select the desired Nav radio.
4) Press the ENT Key to complete the selection.
ENTER A TRANSPONDER CODE
1) Press the XPDR Softkey (XPDR/TFC if the TCAS II option is available).
2) If the aircraft is equipped with two transponders, press the XPDR1 or
XPDR2 Softkey to select the active transponder. If these softkeys are not
present, proceed to step 3.
3) Press the CODE Softkey to display the transponder code selection softkeys,
for digit entry.
4) Press the digit softkeys to enter the code in the code field. When entering
the code, the next key in sequence must be pressed within 10 seconds, or
the entry is cancelled and restored to the previous code. Five seconds after
the fourth digit has been entered, the transponder code becomes active.
SELECT TRANSPONDER MODE
With TCAS II Option
1) Press the XPDR/TFC Softkey.
2) Press the MODE Softkey to display the transponder mode selection
softkeys.
3) Press the desired transponder mode softkey (STBY, ON, or ALT).