Instruction Manual

Page 7-54 G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
Revision 3 190-00716-01
22. Once AFCS PFT is complete and GPS has acquired satellites, verify on PFD1 and PFD2 the ESP
Roll Indices are not displayed at 45° on the roll indicator on the Attitude Display.
23. On the GCU, rotate the inner FMS knob to activate the AUX – SYSTEM SETUP page.
24. On the MFD AUX – SYSTEM SETUP page press the SETUP 2 softkey.
25. Verify that on the MFD SETUP 2 page there is a window for Stability & Protection and the status
is “ENABLED”.
26. Verify on PFD 1 and PFD 2 that there are no “ESP FAIL” or “ESP OFF” alert messages.
27. On the GMC 710, couple the Flight Director to the right side by pressing the XFR button. The
arrow that is illuminated indicates which side is coupled. No flight director modes should be
active at this time.
NOTE
On power up the coupled side will default to the left side. Each time power is
reapplied couple back to the right side and continue test steps.
28. Repeat step 1 thru 27 while coupled to right side.
29. Remove power to the aircraft and avionics systems by setting the aircraft AVIONICS MASTER
PWR, EXT PWR and BAT switches to OFF.
30. Wait ~ 1 minute before re-applying power for further testing as required.