Instruction Manual

Page 7-56 G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
Revision 3 190-00716-01
3. Use the large FMS knob to scroll the cursor to GSR1 (if GSR 56 is installed). Record the GSR 56
serial number shown in the LRU INFO field.
For previously activated systems, if the GSR 56 satellite receiver unit is replaced, the new unit serial
number must be registered with Garmin Flight Data Services. Contact Garmin Product Support and
follow the activation procedure as described previously in this section.
For previously activated systems, if the GDL 59 wi-fi datalink unit is replaced, the system must be
registered again. This can be accomplished by entering the same passcode received during the intial
activation process as described in the following steps:
1. Connect to an available network (reference Section 7.28 for details.)
2. Using the large FMS knob, select the AUX page group on the MFD. Using the small FMS knob,
select the AUX-REPORT STATUS page.
3. Press the MENU key on the GCU to display the PAGE MENU window.
4. With the “Register With GFDS” option highlighted, press the ENT key on the GCU to display
the GARMIN FLIGHT DATA SERVICE REGISTRATION window.
5. Using the keypad on the GCU, enter the access code (provided by Garmin Product Support
during the initial activation of the system) in the NEW REGISTRATION - ACCESS CODE field
and press the ENT key on the GCU.
NOTE
The replacement GDL 59 unit must be registered again, even if the MFD
already shows REGISTERED in the STATUS window.
6. With the REGISTER field highlighted, press the ENT key on the GCU.
7. Verify that the STATUS field indicates REGISTERED and that the data displayed in the
CURRENT REGISTRATION field matches the aircraft information.