FAA Approved Airplane Flight Manual Supplement

Hawker Beechcraft C90A, C90GT and C90GTi King Air 190-00682-02 Rev. E
Page 76 of 124 FAA APPROVED
NOTE
Some RNAV (GPS) approaches provide a vertical descent angle as an aid in flying a stabilized
approach. These approaches are NOT considered Approaches with Vertical Guidance (APV).
Approaches that are annunciated on the HSI as LNAV or LNAV+V are considered Nonprecision
Approaches (NPA) and are flown to an MDA even though vertical glidepath (GP) information may
be provided.
6. At the FAF ........................................................................ Descend via GP if LNAV+V approach
Use desired vertical mode to fly the approach’s vertical profile if LNAV approach
Use Altitude Preselect to level off at intermediate altitudes and at the MDA
NOTE
It is recommend to descend at 1000 ft/min or less. Descending at a higher rate of descent or
reaching MDA too far before the Visual Descent Point (VDP) could cause TAWS alerts. If a
TAWS WARNING is issued, immediately follow the TAWS WARNING procedure in the
EMERGENCY PROCEDURES Section of this AFMS.
CAUTION
Airplane will not capture ALT if descending in GP mode.
7. Level airplane in ALT mode at MDA .............................. PRESS NAV button 200 ft above MDA
If airplane is descending via GP, GP will extinguish and PIT mode will be active and airplane
will capture MDA.
8. AFTER LEVELING AT MDA ...................... SET Missed Approach Altitude In Altitude Preselect
VOR APPROACH
1. Load the approach into the Active Flight Plan .................................... VERIFY the G1000 tunes
the proper VOR frequency
2. Approach Minimums ...............................................SET ON TMR/REF page (if not already set)
IF Flying Vectors-To-Final:
3. Airplane on Vectors-To-Final
a. Mode Control Panel .................................................. PRESS HDG to fly ATC radar vectors
b. PROC button on PFDs or MFD .......................SELECT ‘ACTIVATE VECTORS-TO-FINAL’
NOTE
SUSP may annunciate on the HSI when Vectors-To-Final is selected. The flight plan will
automatically unsuspend when the airplane intercepts and turns inbound on the final
approach course. When automatic flight plan waypoint sequencing resumes, SUSP will
extinguish.
c. HSI CDI ....................................................................... PRESS until VOR navigation source
To be used for the approach displays
d. Course Pointer ..................................................... Set to inbound course (if not already set)
e. Mode Control Panel ......................................................... PRESS APR, verify VAPP armed