Instruction Manual

Page 3-16 G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
Revision 4 190-00716-01
10. Once successfully completed, the following message/window will pop-up. Click Finish to finalize SD card.
3.8.3 Software Files
Software files are defined by part number and version number on the General Arrangement drawing. See
Table 1-2 for the correct General Arrangement drawing part numbers. Each G1000 / GFC 700 LRU
reports the software version it currently contains to the user in two places.
• Normal System Mode: The AUX – SYSTEM STATUS page lists each LRU and the reported
software version.
• Configuration Mode: The SYSTEM STATUS page (SYSTEM page group) reports more
detailed LRU information, including software version, part number, and LRU status.
Software files are loaded to LRUs from the SYSTEM UPLOAD page in configuration mode.
See Section 3.9.2.
3.8.4 Configuration File Descriptions
There are configuration files for baseline settings and various options. Configuration files contain preset
selections for input/output channels, aircraft-specific settings, and LRU-specific settings.
IMPORTANT!
Certain software and configuration files are REQUIRED to be re-loaded during
maintenance that involves removal and replacement of G1000 equipment.
Refer to Section 7 for re-configuration requirements for each G1000 LRU. Pay
special attention to the configuration of options for the G1000.