Instruction Manual

Page 3-28 G1000 / GFC 700 System Maintenance Manual - 300/B300 Series King Air
Revision 4 190-00716-01
3.14 GTX 3000 Configuration
This STC only certifies the GTX 3000 interfacing with the Garmin TCAS II. The GTX 3000 is
compatible with other suppliers TCAS II system but it’s not part of this STC and therefore it
cannot be installed with a third-party TCAS II system. Coordinate the GTX 3000 configuration
with Section 7.5 “GTX 33( ) or GTX 3000 Transponder”.
1. With the loader card in the top slot of PFD1 and PFD1 in configuration mode, select the “System
Upload” page using the PFD1 small FMS knob.
2. Activate cursor and rotate the small FMS knob to display the drop down menu. Rotate the small
FMS knob to highlight “King Air – Garmin Options” and press ENT key on PFD1.
3. Rotate the small FMS knob to highlight “King Air - GTX 3000”. Press ENT key on PFD1.
4. Verify “King Air - GTX 3000” is displayed in the “Item” window. Press “LOAD” softkey.
5. Monitor load progress. Verify software load completes without errors as indicated by the
following:
• Green “PASS” in the Configuration and Software columns for each item loaded.
• “Upload Complete………….COMPLETE” in the summary box.
6. Press ENT key on PFD1 to acknowledge upload complete.
7. Deactivate cursor.