Instruction Manual

Remove the upper bolt from the shroud, See Fig-
ure 6. Install the second standoff spacer (item 1).
Insert the bolt (item 17) through the lock washer
(item 14) through the Channel (item 4) and nally
through the standoff spacer and into the shroud
as shown in Figure 6. (Use Loctite on threads.)
Tighten both the upper and lower bolts securely,
See Figure 7. Make sure the channel stays parallel
as you tighten the bolts as shown in Figure 8.
Figure 6
Figure 7
Figure 8
Keep Channel Parallel
6