Instruction manual

Figure 12
Figure 13
Step Four: Cylinder Rod Eye
Place the Rod Eye (item 31) over the vertical
pin in the Rod Eye Mounting Bracket (item 2)
as shown in Figure 12. (Leave the cylinder at-
tached) Install the Medium Hair Pin Cotter (item
13) through the hole in the vertical pin. Turn the
Cylinder (item 34) Fittings (item 35) up.
Step Five: Stern Pivot Pin
Slip the stern pivot pin (item 3) through the
back of the channel. See Figure 13
8
Figure 14
Figure 15
Step Six: Cylinder End Cap
Line the hole in rear end cap of the
Cylinder (item 34) with the hole in the
top of the vertical pin stern part of the
cylinder mounting Channel assembly
(item 4).
Slide the Clevis Pin (item 19) through
the hole into the Stern Pivot Pin. Put
the Large Hair Pin Cotter (item 12)
through the cross holes in both Pins.