User's Manual

GARNET GAE-3030
15
file> <PHY flash image file>
file names instead of the default file
names.
2.12.2.3 Examples
Consider the case where the default file names are used. Run the utility from the
same directory the PHY files are located:
Example : phycon –d Will use the default file names to generate
tftpupdt.nof
Consider the case where the files to use are readfls.idm, progfls23.idm, and
rt930a.bnm:
Example: phycon –f readfls.idm progfls23.idm rt930a.bnm Will use the
given file names to create tftpupdt.nof
2.13 VCI/VPI Value Configuration.
Connect PC to Modem by RJ-45 cable and RS-232 cable, switching power on of
the modem and set up Hyperterminal at Com 1(or Com 2) port for connection
between Modem and PC.
- At the Hyper terminal window, you can see prompt
0:20:2b:8d:40> help <enter>
and you can find existing list of available commands.
- To check existing VCI/VPI value, put in
0:20:2b:8d:40> bridge device
- To delete existing VPI/VCI value, put in
0:20:2b:8d:40> config reset <enter>
0:20:2b:8d:40> config save <enter>
0:20:2b:8d:40> restart <enter>
- To set up new VPI/VCI value, put in
0:20:2b:8d:40> bridge device add edd <enter>
0:20:2b:8d:40> bridge device add //bun/port=atm/txvci=32/txvpi=0/rxvci=32/rxvpi=
0/rfc1483=true <enter>
0:20:2b:8d:40> config save <enter>
0:20:2b:8d:40> restart <enter>