User's Manual

2350699 Rev. A
§2.6 RF exposure considerations:
The host product operating conditions must be such that there is a minimum separation
distance of 20 cm between the antenna radiating structures and nearby persons. The
host manufacturer is obligated to confirm the use conditions of the host product to
ensure that the distance specified in the instructions is met. In this case the host product
is classified as either a mobile device or a fixed device for RF exposure purposes.
Maximum EIRP of the module is 8.8 dBm, below the 20 mW low power transmitter
output exemption for RF Exposure.
The following statement must be included as a CAUTION statement in manuals and
OEM products to alert end users of FCC RF Exposure compliance:
To satisfy FCC RF Exposure requirements for mobile and base station transmission devices, a
separation distance of 20 cm or more should be maintained between the antenna of this device and
persons during operation. To ensure compliance, operation at closer than this distance is not
recommended. The antenna(s) used for this transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
§2.7 Antennas:
The WLBC uses a non-detachable Printed IFA (Printed Inverted F Antenna) on the
module, thus no antenna other than that furnished by the responsible party shall be
used with the device.
§2.8 Label and compliance information:
Host product manufacturer must provide a physical label stating “Contains FCC
ID: DBDWLBC6100” and “IC: 20318-WLBC6100” in a visible location on the finished
product.
The module host shall bear the following statement in a conspicuous location on the
host and in the manual:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
.