Quick Start Guide

Assembly and Adjustments
5
Extend shaft, insert washers
1. Release lower stem clamp.
2. Extend lower stem.
3. Press mounting washers into place.
Attach the searchcoil
4. Insert lower stem assembly into
searchcoil bracket.
5. Insert bolt in direction shown, and
lightly hand-tighten bolt.
Connect the searchcoil
6. Fully lengthen lower stem until it snaps
into place; then adjust upper stem to
comfortable length, and close stem
clamps.
7. Wrap cable snugly around stem with
rst turn of cable over the stem.
8. Insert coil connector into back of
control box, making sure to properly
line up connectors, and tighten collar.
Adjusting arm cu (if desired)
9. Use the hex wrench (stored below the
cu) to remove all four screws within
the arm cu.
10. Cu can be moved as many as two slots
forward or two slots backward. (At least
two bolts must be secured through the
cu for stability.)
11. Reinsert all four screws and tighten.
Adjusting stem clamp screws
Your Axiom’s stemp clamp screws may
occasionally need to be slightly tightened
with the included hex wrench. Caution:
overtightening of the stem clamp screws
may result in damaged or broken clamps.
1 2 3
4 5
6 7a
9 10 11
7b 8