User manual

3
4
5

(Reverse side of pinpointer)
2
Fast Retune feature quickly
tunes out mineralized ground,
saltwater, wet sand, and other
challenging environments.
FEATURES
 ON/OFF, Retune, Adjust Button
 Pinpointing Tip
 360° Side-Scan Area
 Exclusive Scraping Blade
 LED Flashlight
 Waterproof Speaker
 Lanyard Attachment Loop
 Sealed Battery Cover
 Ruler in Inches and Centimeters








Powering On
Press and release the button () while holding the detector away from any
metallic objects. You will hear 2 beeps and the LED () will remain on.
Powering Off
Press and hold the button for a half second until you hear a single beep (or
single vibration in Silent Mode), indicating power down.
Changing Settings
The Pro-Pointer AT has three Sensitivity settings and two detection settings:
Audio-plus-Vibrate or Vibrate-only (silent).
To enter adjustment mode, press and hold the button () for 2
seconds—indicated by a single beep followed by a dual-tone beep and
flashing LED. (Note: In Silent Mode, beeps are replaced by vibration pulses.)
The first button press after entering adjustment mode indicates the current
setting. Repeatedly press the button to cycle through the 6 settings:
1 beep = minimum Sensitivity, with audio
2 beeps = medium Sensitivity, with audio (Default setting)
3 beeps = maximum Sensitivity, with audio
1 vibrate = minimum Sensitivity/Silent
2 vibrate = medium Sensitivity/Silent
3 vibrate = maximum Sensitivity/Silent
To exit adjustment mode, press and hold the button for 2 seconds—
indicated by a dual-tone beep (dual vibrate in Silent Mode), or wait 5 seconds
for automatic exit.
Notes:
• Lower Sensitivity settings are recommended to prevent detection of
highly mineralized grounds.
• Detection remains operable during the adjustment mode.
• Settings will be remembered when the unit is switched off and back on.
Fast Retune for Mineralized Ground
To tune out the detection of saltwater, wet sand or highly mineralized
ground, hold the tip of the Pro-Pointer AT to the water, sand or soil and
quick-press the button () for an instant Retune.
If necessary, repeat this Fast Retune to further eliminate any
environmental response. Note: An alternate means of eliminating the
ground response is to reduce Sensitivity.
Lost Pinpointer Alarm
After 5 minutes of being ON without a button press, the Pro-Pointer AT
will begin emitting progressively faster warning chirps for 60 minutes.
Press the power button to reset.
Auto-Off Feature
After one hour of warning chirps, the Pro-Pointer AT will power off
automatically.
Scraping Blade
This rugged edge is ideal for sifting through dirt while searching for the
target. The Pro-Pointer AT’s 360º-side-scan detection allows the detector
to alarm when the blade is passed in close proximity to a metallic target.
Lanyard Attachment Clip
Use to attach the Pro-Pointer AT to your belt, digging pouch or your
detector (if desired).
Holster
Secure to any standard size belt. A metal snap within the holster will
cause the pinpointer to alarm if put away while powered on.
Precisely Pinpointing Large Targets
Slowly scan toward the object until the response increases to full/constant
alarm. Then quick-press the button to instantly retune and narrow the
detection field. Continue scanning toward the object to find its precise
location. Repeat this Fast Retune to further narrow detection field as needed.