User manual

2
Garrett Metal Detectors
ACE 200i
™
3
QUICK START GUIDE
1. Power ON.
Press and release the ON / OFF Power button. The ACE 200i
powers on in the last mode used, automatically adjusts for
ground minerals and is ready to search. The detector
operates with four (4) AA batteries which are already
installed by Garrett. (Factory default mode is Coins.)
2. Select Mode.
Use the Mode button to select a different detection mode,
when desired.
3. Adjust settings.
Adjust Sensitivity setting, if desired.
4. Begin scanning.
Lower the searchcoil to approximately 2 to 3cm above the
ground and scan the coil left and right at approximately
1m/second. The coil must be in motion for target
detection.
ACE 200i CONTROL PANEL
Sensitivity
Setting
MODE
Button
selects detection mode (i.e.
discrimination pattern).
Power ON / OFF:
hold 5 seconds for
Factory Reset.
Depth
Indicator
indicates depth
of coin-sized
target.
Mode
Indicator
Target ID Legend
indicates metal types.
Lower Scale
indicates notch
discrimination
pattern.
Target ID Cursor
indicates probable target identity.
SENSITIVITY
Button
increases or decreases
sensitivity.
Digital
Target ID
Low Battery
Level
Indicator