User manual

Coins: Discrimination is preset to eliminate detection of lower conductivity trash items such as
pulltabs and bottlecaps.
Jewelry: Specifically designed to eliminate trash targets and bottlecaps.
Relics: Specifically designed to eliminate only those very small lower conductivity items that
plague relic hunters.
Zero: No discrimination is programmed into this mode, so essentially every metal target will
give an audio response.
Custom: This mode is designed to be user-set. Through the use of the Accept/Reject
touchpad it can be modified for an individual's preference. The settings made to this mode will
be retained when the detector is turned off.
Note: When the detector is turned off and then back on, it will begin operating in the mode
previously in use.
SETTING DISCRIMINATION:
Setting of Notches
Changes to the preset notches can be made in several ways if so desired. A specific item may
be located by turning off all segments on the Lower Scale except for the segment where that
target will appear. This can be accomplished by pressing the + or - touchpad to locate the
cursor and moving it to the segment that you wish to turn on or turn off. When the cursor is
over that segment, press ACCEPT/REJECT to turn the segment on or off.
Another method is to search normally and when a particular item is encountered, press the
ACCEPT/REJECT touchpad to turn that segment off. That target will not bother you any
longer. NOTE: You may wish to turn off one segment on each side of the one chosen for
rejection. This will mean that three segments are off, but it will also insure that the chosen
target cannot be recognized any longer.
All of the Discrimination Modes may be adjusted in this manner.
All changes made to the user-set Custom mode will retain changes made to them when the
detector is turned off. All changes to the other modes will be lost as they automatically return to
the factory settings.
Factory Settings: Remember that the factory settings may be gained at any time simply by
pressing and holding the POWER touchpad for approximately 5 seconds. The detector will
beep and the voice will announce that all factory set functions have been restored. All changes
made by the operator will have been deleted
All-Metal Operating Mode:
In this mode there is no discrimination. When turning the detector on, or switching to this mode
the Fast Track feature will automatically ground balance the detector and Ground Track will
keep it continually ground balanced.
Hunt in this mode when you desire the greatest depth and recognize that all metal targets will
be reported audibly.