User manual

Bi-Level: Two noticeably different audio sounds are produce when this function is turned on. A
standard audio response is given for all targets of a high conductivity than that of a US nickel.
Nickels and lesser conductive targets cause a lower audio tone. This function is turned on or
off by use of the + or - touchpads.
If neither Belltone nor Bi-Level audio is selected, the detector will operate with only Standard
audio.
Talk: Use of this function allows the operator to select the level of Talk desired using the + or -
touchpads.
Overload: This is a distinct audio sound emitted when the detector encounters an
exceptionally large target fairly near the searchcoil.
Battery Type: By use of the + or- touchpad the type of battery being used is selected. The
scale is automatically adjusted for correct reporting of the battery power available.
Audio Warning: This audio sound will occur only if while making changes or adjustment a
"wrong" touchpad is pressed.
Additional Information: All personal preference adjustments selected will be retained when
the detector is turned off, even when the batteries are removed. However, all Accept/Reject
changes made to the Motion Discriminate factory-set modes will be deleted and those modes
will return to the factory-set default settings.
The detector must be turned off when the batteries are being replaced.
ALL- METAL MODE
OPERATIONAL SETTINGS:
All-Metal Mode: All changes will be reported audibly by the detector’s voice function and all
adjustments are made using the + or – touchpads. These changes are also shown on the
Upper and/or Lower Scales of the LCD Display.
The following list of control functions is used in both operating modes. Instructions for their use
can be found above.
Manual Ground Balance
Depth (Sensitivity)
Threshold
Frequency
Volume
Tone
Search Image
Back Light
Talk
Manual Ground Balance: This function will be used rarely due to the detector’s internal
circuitry and the Ground Track automatic ground balancing method is usually quite
satisfactory. However, when Manual Ground balance is desired, press the Menu touchpad and
scroll to the Manual Ground Bal is displayed. Raise the searchcoil a foot or more into the air