User manual

recommended that only high quality standard, alkaline, or rechargeable batteries be used. It is
advisable to remove the battery holders from the pack and the batteries from the holders when
the detector is not in use, particularly for a period of weeks. The detector should operate 10 to
15 hours with carbon or rechargeable batteries and a longer time with alkaline batteries. After
replacing the batteries perform the factory reset procedure.
Checking Condition:
Battery condition is reported on the LCD Display all the time the detector is turned on.
Batteries should be considered weak when less than three (3) bars are displayed. They should
be replaced when the battery scale reports only one (1) bar, or when the detector begins
making target-like sounds when no target is encountered.
Battery Replacement
1. Turn the detector off.
2. Slide the battery pack to the rear slightly and remove the two battery covers.
3. Take out the two battery holders (which are not connected by wire) by tilting the
detector.
4. Remove the old batteries from the holders.
5. Install the new batteries making certain to observe the polarity of the batteries.
6. Re-insert the holders into the battery pack. Make certain that the rivets on the bottom of
the holders are toward the center of the battery pack when the holders are inserted.
7. Re-install the battery covers and slide the battery pack back into its normal position
beneath the arm cuff.
Note: The detector must be turned off when the batteries are being replaced.
Please note that the detector will lose Audio Threshold and Depth/Sensitivity Settings when
the battery pack is removed from the detector for more than approximately four minutes.
After changing the batteries, it is always wise to perform the factory re-set procedure.
OPERATING INSTRUCTIONS
TO BEGIN: Follow the instructions in the "Getting Started Section" for turning on your detector,
noting the condition of the batteries, and setting of the Audio Threshold and any other function
that may be desired.
MODE DESCRIPTIONS:
ALL METAL: Press and release the ALL METAL touchpad to activate this mode. Hunt in the
All Metal mode when the greatest depth of detection is sought, as when searching for caches
or deep relics. Electronic prospecting will also be carried out in this mode. Because no
discrimination is possible when using this mode, all metal targets will be detected. Use of the
LCD Display will give an indication of what kind of metal has been detected and can eliminate
some needless digging on shallow targets.
Fast Track ground balancing is accomplished in this mode by pressing and holding the ALL