Owner’s Manual TreasureHound Depth Multiplier with EagleEye™ Pinpointing ™
Garrett TreasureHound with EagleEye Pinpointing Depth Multiplier Congratulations on your selection of the Garrett TreasureHound with EagleEye Pinpointing Depth Multiplier. This accessory is designed for use with the Garrett GTI 2500 metal detector. It is a specialized coil system capable of detecting large metal objects at depths much greater than most standard searchcoils. The patented EagleEye Pinpointing searchcoil identifies the precise location of a detected target.
COMPONENTS 2 captive thumb screws to attach front EagleEye coil Use thumb screw/ washer to attach rear coil here Beam assembly Parts bag Rear coil EagleEye Front coil The TreasureHound with EagleEye Pinpointing contains: a front coil with short cable; a rear coil with a long cable; a beam assembly comprising a beam, clamp, detector mounting stem and two 1" captive thumb screws; and a bag of parts containing one 2.25" thumb screw and one #10 washer.
ASSEMBLY 1. Slide end of beam containing the two 1" captive thumb screws onto front coil. Hand tighten thumb screws. 2. Slide rear of beam into rear coil receptacle. Rear coil must be oriented with receptacle fin below beam and cable above beam. Align mounting holes, insert the 2.25" thumb screw with the #10 washer and hand tighten.
3. Wrap rear coil cable snugly around beam and attach to front coil connector. 4. Slide GTI 2500 detector housing onto detector mounting stem to engage spring clip. Wrap front coil cable snugly around beam and detector mounting stem and attach connector to detector.
The fully assembled GTI 2500 and Treasure Hound Depth Multiplier. OPERATING INSTRUCTIONS The GTI 2500 automatically operates in the All-Metal mode when attached to the TreasureHound. AutoThreshold, which maintains the audio threshold at its previously selected level, is disabled. The threshold sound may fluctuate due to changes in temperature or ground conditions. If this occurs, you can retune the audio threshold by simply pressing and releasing the All-Metal button.
The TreasureHound Depth Multiplier should be carried with the forward coil facing down. Do not swing your detector back and forth as you would with a standard searchcoil. SEARCH PROCEDURE Walk forward with the TreasureHound EagleEye Depth Multiplier pointing straight ahead and parallel to the ground. Do not swing it as you would a standard searchcoil. When searching for buried objects, you should walk back and forth, following parallel paths.
to several feet depending on the size of the targeted object. You will detect all types of metal targets, including iron; however, you will not detect most surface trash and small pieces of junk metal. Please note that with the TreasureHound EagleEye Depth Multiplier the ground balance (or elimination) controls are no longer operative.
Caution: In a construction area or other hazardous locations, you may choose not to use the headphones as they may obscure warning sounds. Pinpointing The performance of the EagleEye Pinpointing front searchcoil is similar to that of a 15" searchcoil. To activate the EagleEye Pinpointing searchcoil, simply press and hold the Treasure Imaging (Pinpoint) touchpad and scan the front coil as you would using any standard, single searchcoil.
ground mineralization. For more information, refer to the Manual Ground Balancing section of the detector's owner's manual. If you are unable to locate a target, it may be too deep, in which case you should release the Pinpoint button and locate the target with the Depth Multiplier. Approach the target and mark the ground at the spot where the target begins to respond. Next, approach the target from the opposite direction and make another mark at the spot where the target begins to respond again.
WARNING The following safety measures must be observed at all times: • DO NOT hunt in areas where electric lines, gas/water pipelines, bombs or other explosives may be buried. • NEVER trespass or hunt on private property without permission. • NATIONAL and STATE parks, military sites, monuments, etc., are absolutely "off limits." • ALWAYS exercise caution when digging toward a target where the underground conditions are unknown.
Garrett Metal Detectors 1881 W. State Street Garland, TX 75042 Tel: 1.800.234.6151 Tel: 972.494.6151 Fax: 972.494.1881 E-mail: sales@garrett.com Web: www.garrett.com Garrett Metal Detectors, garrett.com, TreasureHound, EagleEye, Depth Multiplier and Treasure Imaging are trademarks of Garrett Electronics Inc. ©2010 Garrett Metal Detectors. 1525600.D.
Detector Trade International GmbH & Co KG www.detector-trade.de info@detector-trade.de +49 (0) 2133 97 90 20 Hamburger Str. 17 41540 Dormagen Germany www.facebook.com/dtigmbh www.twitter.com/detectortradein www.youtube.
