Installation Guide
INSTRUCTIONS FOR USE: AUTO REEL MODEL NW-25W
1. INTRODUCTION
This product is made with high quality resistant materials. It has a spring mechanism,
which allows the hose to rewind automatically. The hose can be extended to a max of
25m and the reel can turn 180 degrees on its axis. It is advisable to install it in a place
from which you can reach a greater area. Your reel also includes a 2m leader hose.
2. INSTALLATION
2.1 It is advisable for the reel to be installed within 1.2m of the tap.
2.2 Included with your reel is a mounting bracket, template and a fastener pack. This pack
includes 3 screws, 5 plastic anchors and 2 fixing pins.
2.3 The mounting bracket can be installed onto a brick wall or to strong and secure timber.
The most appropriate height to mount your reel is approx 1.2m from the ground. The
wall bracket has three holes (2 at the top of the bracket and 1 in the centre). You can
use the included template to mark where to drill. The 2 holes at the bottom of the
bracket are for the 2 fixing pins. Drill the 5 x holes, knock the plastic anchors into the
surface, knock in the 2 x fixing pins into the bottom plugs ( approx halfway in ), place
the bracket over the fixing pins, then install the screws. Tighten accordingly. The
stainless steel fixing pins must be used!
2.4 To fix the bracket onto BRICK you will need to drill the holes 12mm x 60mm.
2.5 To fix the bracket onto TIMBER you will need to drill the holes 5mm diameter x
60mm deep. ( Plastic anchors are not necessary for timber fixing. )
2.6 Once the bracket is installed, lift the reel and place in the bracket. Connect the leader
hose to the tap using the 1” Brass tap adaptor provided and you are ready to use your
Auto Reel.
3. USING THE REEL
The reel includes a high-quality garden hose.
3.1 Always retract the hose into the housing after use to prolong the life of the hose.
3.2 It is advisable to turn the water off and release the pressure from the hose before
retracting.
Tool Requirements:（*Not supplied）
Electric Drill
1 x 12mm SDS Drill Bit
(For brick/concrete installation)
1 x 7mm Drill bit (For Timber
installation)
Hammer
Hex-head driver