Specification

6
Fitting under wall unit
Note 1: Before attaching the hood to the wall unit, drill a hole of 6 �/₂＂diameter into the wall unit.
Note 2: In any case, check the position of the power outlet where the power cable will run, since a
hole might have to be made in the wall unit to accommodate it.
1. Take off the aluminum filter from the hood body as shown on PIC. 1.
2. Unscrew 2 screws as shown on PIC. 2, and take off the front panel from the hood body.
3. Have the cut-out size for the wall unit according to PIC. 3. Hold up the body and insert the
hood body into the wall unit as shown on PIC. 3.
4. Fix the hood body to the wall unit with 4 screws ST3.9*25 as shown on PIC. 4.
5. Install the front panel back to position with 2 screws M4*8 as shown on PIC. 5.
6. Install the aluminum filter back to position.
7. Fix the flexible pipe to the air outlet with 2 screws ST2.9*6. Then the installation is done.
2.Unscrew the screws M4*8 and take out the SS panel. 1.Take out the aluminum filter.
screws M4*8(2pcs)
3.Insert the hood body to the wall unit.
Board of wall unit
4.Fix the hood body to the wall unit with screws.
Screws 3.9*25 (4pcs)
5.Install the SS panel back to position. 6.Install the aluminum filter
7.Fix the pipe to the air outlet.
Screws M4*8 (2pcs)
Aluminum filter
Screws 2.9*6 (2pcs)
27.8″
10 .
2″
[phone] [e-mail]
www.gaslandchef.com
3330-A Marathon Ct Charleston, SC 29418