User Manual

ManualsBrandsGasmate ManualsHeatersStellar Black Deluxe Area Heater

03908 04/19

IMPORTANT: RETAIN THESE INSTRUCTIONS FOR FUTURE USE

FOR YOUR SAFETY

If you smell gas:

1. Shut off the gas to the appliance.

2. Extinguish any open ﬂame.

3. If odour continues, immediately call your gas supplier.

Do not store or use gasoline or other ﬂammable vapour

and liquids in the vicinity of this or any other appliance.

WARNING

Improper installation, adjustment, alteration, service or

maintenance can cause injury or property damage.

Read the instructions thoroughly before installing or

servicing this equipment.

FOR OUTDOOR USE ONLY

PROPANE GAS

Model No. AH2067ODS & AH2066

The ideal solution for extending the season of

outdoor entertaining

Creates a stylish and attractive ambience

Rotary ignition

Includes a safety ‘tip-over’ switch that halts supply of

gas to the unit should it be accidentally knocked over

Oxygen depletion system for enhanced safety

Stainless steel burner for extra long-term reliability

Complete with hose and POL regulator

Efﬁcient and powerful 40MJ/h output

Adjustable heat output

Operates for approximately 9 hours on a properly

ﬁlled 9Kg Propane cylinder

For outdoor use only

Gas certiﬁed to Australian standards

STELLAR BLACK

DELUXE AREA HEATER

Summary of content (8 pages)

PAGE 1
STELLAR BLACK DELUXE AREA HEATER Model No.
PAGE 2
Installation, Operation and Maintenance Instructions INSTALLATION 3. Important Safety Rules This appliance must only be used in a well ventilated area. Minimum Clearance from Combustibles: 1. Side 500 mm Ceiling 1000 mm This appliance shall not be installed or used indoors, in buildings, garages or any other enclosed area. 500 mm Combustible materials are considered to be wood, compressed paper, plant fibres, plastic, plexiglas or other materials capable of being ignited and burned.
PAGE 3
7. The hose must be protected from contact with hot or sharp surfaces both during use and while in storage. The hose assembly should be visually inspected prior to each use of the heater. If excessive abrasion or wear is evident, or the hose is cut, it must be replaced prior to operating the heater. The replacement hose assembly may be obtained from the manufacturer. 8. DO NOT use any pressure regulator or hose assembly other than those supplied with the appliance.
PAGE 4
AREA HEATER ASSEMBLY Tools Required Phillips head screwdriver 2 Adjustable spanners Note: Remove any transit protection material Burner head assembly STEP 1 Secure the base to the cylinder house body with five M8 x 12mm long bolts. STEP 2 Secure the burner head to the inside of the cylinder house body with five M5 x 8mm long screws, washers and nuts. STEP 3 Securely attach the hose to the burner head and the regulator to a gas cylinder, check the connections for leaks using a soapy water solution.
PAGE 5
AREA HEATER - For Outdoor Use Only 1000mm Minimum Clearance from Combustible Surfaces*: 500mm 630mm 1330mm g 540mm *Combustible materials are considered to be wood, compressed paper, plant fibres, plastic or other materials that are capable of being ignited and burned.
PAGE 6
TEST FIRING HEATER Test fire heater, following the lighting instructions. Leak test all gas connections with soapy water. Soap bubbles indicate gas leakage. DO NOT use a match to test for gas leaks. WARNING: White smoke may appear around the radiant head during the first minute of the initial firing.
PAGE 7
SAFE APPLIANCE LOCATIONS This appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection. Any enclosure in which the appliance is used shall comply with the following: An enclosure with walls on all sides, but at least one permanent opening at ground level and no overhead cover (see Example 1).
PAGE 8
For any queries or assistance call Customer Service (Australia Only) 1300 174 876 Hours of operation: Monday to Friday 8am - 5pm EST Do not return to place of purchase. Keep your purchase receipt, this will be required to make any claims under the 12 month warranty.