Operating instructions

current of 30 mA in the supplying electrical circuit is recommended. If in doubt, contact your

electrician for further information.

• Always unplug the appliance when not in use and before moving or cleaning the appli-

ance. Do not leave the appliance unattended while connected to the power supply.

• Keep the cord away from hot surfaces, including the stove. When the power cord warms

up during operation or is likely to be damaged, it must be replaced by an authorised service

centre. Do not attempt to repair the power cord!

• Do not immerse the pitcher or power cord in water or any other liquid.

Hot Surfaces – Risk of Burns

The milk frother is used for frothing and heating milk. During operation the inside of the

pitcher and the Lid heat up.

• Dry spilled liquids immediately. When moving the filled pitcher, close supervision is

necessary to keep the pitcher in an upright position to avoid spilling, and thus avoid injuries

and damage. Use the handle to lift the pitcher.

• The interior of the pitcher and Lid heat up during operation. Always keep your hands,

face and arm as well as any clothing and other heat-sensitive objects out of the pitcher du-

ring operation or shortly after to avoid injury - risk of getting burned. Wait for the appliance

to cool down. Do not place any objects or clothes on or in the appliance during operation

to avoid overheating. Before filling the pitcher ensure no foreign objects are inside the pit-

cher.

• Always place the appliance on a stable, level, dry, heat-resistant and easy accessible

surface (i. e. glass, ceramic, stone).

• Ensure the appliance is properly assembled, the attachment is locked in position and

the correct amount of milk is filled into the pitcher before turning the appliance on. Do not

overfill the pitcher.

• Always keep the Lid except Flavour Hatch closed during operation. The rotation of the

attachment during operation can cause spilling when the Lid is getting removed. Do not hold

your face, hands, other parts of your body, or heat-sensitive objects over the Lid or spout,

and always beware of hot steam, when opening the Lid after operation to avoid scalding.

• Never place any heat-sensitive objects on the appliance when in use to prevent damage

from heat, condense water and splatter.

• Unplug from outlet when not in use and before cleaning. Allow unit to cool before assem-

bling or disassembling units, and before cleaning the appliance.

• Never operate the appliance without milk, water, or other appropriate ingredients in the

pitcher. Failure to do so can result in damage to the appliance. If a problem appears, return

appliance to authorised service centre or factory for repair. Do not attempt to repair. Appli-

ance contains no user serviceable parts.

• Do not use appliance for anything other then intended use.

• Ensure the Froth Whip and the Whip Holder are correctly assembled.

• Beware of hot steam when removing Lid.