Manual

PREPARATION
Tools Required for Assembly: (Not included)
• Pencil
• Electrical drill with 5/16 in. drill bit
CAUTION: Molly bolts are for dry walls only.
Use tile anchors for tile surfaces. (Not included)
CAUTION: This item is not intended to be mounted in shower
INSTALLATION INSTRUCTIONS
1. Mark four points using a measuring tape and a level as reference points
for mounting brackets. (Fig.1)
2. Remove mounting brackets (A) from back plates and mark holes on wall. (Fig.2)
Drill 5/16 in. pilot holes into the wall where the Molly bolts will be inserted
using an electrical drill.
3. Tap Molly bolts (B) into the pilot holes using a mallet hammer.
Use an electrical screwdriver to tighten the screws.
This will collapse the Molly bolts (B) tightly to the wall. (Fig. 3)
4. Unscrew the screws (b) from the Molly bolts.
Molly bolts (B) will remain in the wall. (Fig. 4)
5. Place the mounting bracket (A) over the Molly bolts (B).
Insert the screws (b) back through the bracket and the Molly bolts,
tighten firmly with Phillips head screwdriver. (Fig. 5)
Repeat step 2-5 for all four mounting brackets.
6. Secure Bracket arms on both sides by tightening setscrews of
back plates with Allen wrench (D). (Fig.6)
7. Starting from the top, insert glass pieces and tighten screws at the each
end with Phillips head screwdriver. (Fig.7)
If necessary, adjust the distance between bracket arms so that the glass pieces are snug.
Loosening back plate setscrews and re-tightening (Fig.6) will allow about ½”
adjusting room on each side.
8. Adjust the middle tier to a desired position by using the Allen wrench. (D) (Fig.8)
CARE AND MAINTENANCE
To maintain the beautiful luster finish, please use soft damp cloths when cleaning and never use any cleaning solvents.
• Phillips head screwdriver
• Safety glasses
• Mallet hammer
• Measuring tape
• Level
GENERAL INSTALLATION INSTRUCTIONS
ADJUSTABLE GLASS SHELF Item# 1394
Fig. 3
Fig. 4
Fig. 5
Side View
Side View
B
b
Fig. 7
D
C
Fig. 8
D
Fig. 1
Fig. 6
Fig. 2
A
b
EF
B
A
B
Side View
22-
3
/8”
21”