Installation Guide

PREPARATION
Tools Required for Assembly: (Not included)
• Pencil
• Electrical drill with 5/16 in. drill bit
• Mallet
CAUTION: Molly bolts are for dry walls only. Use tile anchors for tile surfaces. (Not included)
INSTALLATION INSTRUCTIONS
1. Hold the item up against desired position on wall,
and outline the back plates (A) of end pieces with a pencil. (Fig. 1)
Use a measuring tape and a level for accuracy.
2. Position a mounting bracket (B) in the center of outlined back plate.
Use a pencil to mark positioning of the screw holes. (Fig. 2)
3. Drill 5/16 in. pilot holes into the wall where the molly bolts
will be inserted using an electrical drill.
4. Tap molly bolts into the pilot holes using a hammer.
5.Use an electrical screwdriver to tighten the screws.
This will collapse the molly bolts (E) tightly to the wall. (Fig. 3)
6.Unscrew the screws (e) from the molly bolts.
Molly bolts will remain in the wall. (Fig. 4)
7. Place the mounting bracket (A) over the molly bolts (E). Insert
the screws (e) back through the bracket and the molly bolts,
then tighten firmly with Philips head screwdriver. (Fig. 5)
8. Repeat 2-7 for the other mounting brackets.
9. Secure the end piece (A) with Allen wrench (D)
and set screw (C). (Fig. 6)
CARE AND MAINTENANCE
To maintain the beautiful luster finish, please use soft damp cloths
when cleaning and never use any cleaning solvents.
• Philips head screwdriver
• Tape measure
• Level
• Safety glasses
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Side View
Fig. 1
INSTALLATION INSTRUCTIONS
HOTEL TOWEL CENTRE
B
Front View
A
E
e
e
E
B
C
D
A
For more Gatco Collections WWW.GATCOINC.COM
Gatco, Inc. 1550 Factor Ave. San Leandro CA, 94577
Phone: [phone] · 800.227.5640 Fax: [phone]