Instruction Manual

PREPARATION
Tools Required for Assembly: (Not included)
• Electrical drill with 5/16 in. drill bit (Masonry drill bit for tile surfaces)
• Pencil / Pen
• Mallet hammer
CAUTION: Tiles anchors are for tile walls only. For drywall installations please use drywall anchors provided.
INSTALLATION INSTRUCTIONS (Tile anchors)
1. Hold up the corner shower shelf against a desired corner and
mark four screw holes with appropriate writing tools. (Fig. 1)
Use a level for accuracy.
2. Drill 5/16 in. pilot holes into the walls using an electrical drill
with a masonry drill bit where the drywall anchors will be inserted.
3. Tap in plastic tile anchors (A) using a mallet hammer
until they are flush with walls. (Fig. 2)
4. Place the corner shower shelf over the holes and tighten screws
using philips head screw driver. (Fig.3)
INSTALLATION INSTRUCTIONS (Drywall anchors)
1. Hold up the corner shower shelf against a desired corner and
mark four screw holes with appropriate writing tools. (Fig. 1)
Use a level for accuracy
2. Drill 5/16 in. pilot holes into the walls using an electrical drill
where the drywall anchors will be inserted.
3. Pinch drywall anchors (B) two wings together (Fig. 4),
and insert it into the hole horizontally.
Tap flush with the wall using a hammer.
4. Insert the red push pin (C) into the drywall anchors (B)
until the wings pop open, (Fig. 5) then remove the pin.
Do not tap the red push pin with a hammer.
5. Tap in plastic drywall anchors using mallet hammers
until they are flush with walls.
6. Place the corner shower shelf over the holes and tighten screws
using philips head screw driver. (Fig. 6)
• Philips head screwdriver
• Level
• Safety glasses
GENERAL INSTALLATION INSTRUCTIONS
Corner Shower Shelf (# 1590, #1591)
SIDE VIEW
(Fig. 1)
(Fig. 2)
Corner
Shower Shelf
(Fig. 3)
SIDE VIEW
SIDE VIEW
(Fig. 4)
Corner
Shower Shelf
(Fig. 6)
SIDE VIEW
Push
B
C
SIDE VIEW
(Fig. 5)
A
B