Installation Guide

ManualsBrandsGatco ManualsHome DecorMarina 26.5 in. x 24 in. Beveled Single Oval Mirror in Chrome

• Philips head screwdriver

• Tape measure

• Level

• Safety glasses

7.Unscrew the screws (f)

from the molly bolts.

Molly bolts will remain in the

wall. (Fig. 4)

8. Place the mounting bracket

Insert the screws (f) back

through the bracket and the

molly bolts, then tighten

firmly with Philips head

screwdriver. (Fig. 5)

9. Secure the end piece (A)

with Allen wrench (G) and set

screw. (D) (Fig.6)

10. Tilt the mirror (B) at the

desired angle and tighten the

pivoting brackets (A)

using the Allen wrench (G)

and set screws (D). (Fig. 7)

1. Slide on left and right

pivoting brackets (A) to the

oval mirror (B) at the

mounting plate. Tighten

mirror bracket set screws (E)

firmly by hand using

a Philip head screwdriver.

(Fig. 1)

CAUTION: Do not use

electrical drill/screwdriver to

tighten the mirror bracket set

screws as it may damage the

products.

2. Hold assembled item up

against desired position on

wall, and outline the back

plates of end pieces with a

pencil. Use a measuring tape

and a level for accuracy.

(Fig. 2)

3. Position a mounting bracket

in the center of outlined back

plate. Use a pencil to mark

positioning of the screw holes.

4. Drill 5/16 in. pilot holes

into the wall where the molly

boltswill be inserted

using an electrical drill.

5. Tap molly bolts into the

pilot holes using a hammer.

6.Use an electrical screwdriver

to tighten the screws.

This will collapse the molly

bolts (F) tightly to the wall.

(Fig. 3)

PREPARATION

Tools Required for Assembly: (Not included)

• Pencil

• Electrical drill with 5/16 in. drill bit

• Hammer

CAUTION: Molly bolts are for dry walls only. Use tile anchors for tile surfaces. (not included)

CAUTION: Two people are required to safely install this oval mirror. The mirror will break if dropped.

Take extra precautionary measures to ensure a secure grip on the parts.

INSTALLATION INSTRUCTIONS

CARE AND MAINTENANCE

To maintain the beautiful luster finish, please use soft damp cloths when cleaning and never use any cleaning solvents.

GENERAL INSTALLATION INSTRUCTION

MIRROR

Fig. 1

Back View

Front View

Fig. 2

Fig. 3

Side View

Fig. 4

Fig. 5

Side View

Fig. 6

Side View

Fig. 7

Summary of content (1 pages)

PAGE 1
GENERAL INSTALLATION INSTRUCTION MIRROR PREPARATION Tools Required for Assembly: (Not included) • Pencil • Electrical drill with 5/16 in. drill bit • Hammer • Philips head screwdriver • Tape measure • Level • Safety glasses CAUTION: Molly bolts are for dry walls only. Use tile anchors for tile surfaces. (not included) CAUTION: Two people are required to safely install this oval mirror. The mirror will break if dropped. Take extra precautionary measures to ensure a secure grip on the parts.