Installation Guide

Fig. 1
Fig. 2
Fig. 3
Fig. 4
1. Remove flange cap
from base by twisting
counter-clockwise.
(Fig. 1)
4. Fasten mounting
bracket to wall with
mounting screws.
(Fig. 4)
2. Use back plate as an
outline to mark desired
position on wall and
location of mounting
screw holes.
(Fig. 2)
5. Place back plate
over bracket and
retighten set screw.
(Fig. 5)
6. Using hack saw,
cut shower rod to
desired length
(if necessary).
Shower rod ends
should fit flush
between two back
plates. (Fig. 6)
7. A) Slide flange caps
onto ends of curtain
rod, B) with flange
caps on the end of
rod, tighten flange
caps onto each base
by applying pressure
and turning
clockwise. (Fig. 7)
3. Drill 5/16 in. pilot holes
into the wall where
the molly bolts will
be inserted using an
electrical drill. Tap molly
bolts into the pilot
holes using a hammer.
Use an electrical
screwdriver to tighten
the screws. This will
collapse the molly bolts
tightly to the wall.
Unscrew the screws
from the molly bolts.
Molly bolts will remain
in the wall. (Fig. 3)
CARE AND MAINTENANCE
To maintain the beautiful luster finish, please use soft damp cloths when cleaning and never use any cleaning solvents.
PREPARATION
Tools Required for Assembly: (Not included)
• Pencil
• Electrical drill with 5/16 in. drill bit
• Hammer
• Philips head screwdriver
• Tape measure
• Level
• Safety Glasses
• Hack saw
CAUTION: Drywall anchors are for drywalls only. Use tile anchors for tile surfaces. (Not included)
INSTALLATION INSTRUCTIONS
GENERAL INSTALLATION INSTRUCTION
Shower Curtain Rod
Fig. 5
Fig. 6
Fig. 7
BASE
FLANGE CAP

WALL



A
B


CURTAIN ROD
CUT ROD LENGTH BETWEEN HERE
TO FIT (IF NEEDED)
 


A
B