Installation Guide

PREPARATION
Tools Required for Assembly: (Not included)
Pencil
Electrical drill
CAUTION: Wood blocking is preferable behind all wall surfaces. If wood blocking is not available,
the following optional fasteners are suggested: Tile/Masonry – Plastic or lead anchors
Plaster/Drywall – Toggle bolts
INSTALLATION INSTRUCTIONS
1. Uncover the wall flange under the cover flange.
Hold the grab bar up against desired position on wall,
and mark the positioning of the screw holes.
Use a measuring tape and a level for accuracy.
2. Install grab bar with 4 - #10 × 2” panhead stainless steel
screws provided for each end wall flange.
3. Slide cover flanges over wall flanges and press
firmly to complete installation.
CARE AND MAINTENANCE
To maintain the luster finish, please use soft damp cloths when cleaning and never use any cleaning solvents.
Tape measure
Level
Safety glasses
Latitude
2
Grab Bar
General Installation Instructions
Wall Flange
Cover Flange
Wall Flange Front View
Screws
Screws

Summary of content (1 pages)