Installation Guide

ManualsBrandsGatehouse ManualsSecurity Doors918230554E

202220972

Patio Door Installation Instructions

Recommended Tools

DESCRIPTION QTY

1/4x4’’ one-way screw 8

1/4x1’’ one-way screw 8

1/4x1’’ self-drilling hex-head screw 8

Large End Cap 4

Mounting Bracket 8

Small End Cap 2

Drill, One-Way tool (provided),

3/16’’ Drill Bit, Tape Measure,

Pencil, 3/8’’ Socket Driver

BEFORE YOU START

• Read the complete installation instructions before proceeding with installation

• Installation may require two people when lifting and installing the door

• Use appropriate protective equipment

• Do not allow children to play with the door

• Failure to install door properly could result in an injury

• Gatehouse is not responsible for accidents or injury resulting from the use or

installation of this product

PREP STEPS

• Verify opening size with size shown on the box

• Make sure door trim is securely fastened and square

Hinge and

latch rails

are attached

directly to

the mounting

surface.

The door remains

flush with the surface

but extends the

mounting range to fit

larger openings. If the

extended mount plus

a 2’’ offset is required,

it may be necessary

to build out your

mounting surface.

The door can be installed to operate from either the left or the right as viewed

from the outside. Right operating door shown in these instructions.

1 Determine if the Door will be Right or Left Operating

2 Install the Handle and Deadbolt using the Manufacturer’s Instructions

RIGHT OPERATING LEFT OPERATING

STANDARD MOUNT EXTENDED MOUNT

PRIME

DOOR

LATCH

RAIL

MOUNTING

BRACKET

DOOR

FRAME

MOUNTING

BRACKET

Open the door and hold it up to the opening as shown.

The door should be centered vertically over the opening

for all mounting methods. Operate the door and inspect

for possible interference that might affect the placement

of the mounting brackets or operation of the door. Select

appropriate mounting method.

To support the weight of the door, installation screws

must hit a solid surface.

Important: Top and bottom brackets are required on

all mounting methods

3 Check for Obstructions and Select

Mounting Method

Projects the door

up to 2” off the

surface to avoid

obstructions.

STANDOFF

MOUNT

Summary of content (2 pages)

PAGE 1
Patio Door Installation Instructions Recommended Tools DESCRIPTION QTY 1/4x4’’ one-way screw 8 1/4x1’’ one-way screw 8 1/4x1’’ self-drilling hex-head screw 8 Drill, One-Way tool (provided), 3/16’’ Drill Bit, Tape Measure, Pencil, 3/8’’ Socket Driver AA CC Large End Cap 4 Mounting Bracket 8 Small End Cap 2 202220972 BB BEFORE YOU START • • • • • • DD PREP STEPS • Verify opening size with size shown on the box • Make sure door trim is securely fastened and square 1 Read the complete ins
PAGE 2
4 5 Install End Caps Lay the door on a solid, flat surface. Push the 4 larger end caps into the holes in the top of the door. Push the two smaller end caps into the holes at the top of the latch rail and hinge rail Position the Mounting Brackets With a pencil, mark the position of all brackets on both the door and latch rail according to the mounting method chosen. Ensure the top and bottom brackets are on the stationary side of the door.