Installation Guide

9 Position and Mount Latch Rail
With the door closed, align the
latch rail next to the door ensuring
there is a 1/8’’ gap between the
latch rail and the door. Confirm
the door opens and closes
smoothly, and the handle and
deadbolt operate. Repeat Step 8
to mount the latch rail using three
1/4x4’’ one-way screws.
Lay the door on a solid, flat surface. Push the 4 larger end caps
into the holes in the top of the door. Push the two smaller end
caps into the holes at the top of the latch rail and hinge rail
4 Install End Caps
1/4x4’’ ONE-WAY SCREW
QTY: 3
EXTENDED MOUNT STANDARD MOUNT
With a pencil, mark the position of all brackets on both the door
and latch rail according to the mounting method chosen. Ensure
the top and bottom brackets are on the stationary side of the door.
If Standard Mount was chosen, only the top and bottom brackets
are used.
Once the mounting brackets are screwed in place, they
cannot be easily removed. Ensure the fit and appearance is
satisfactory before brackets are attached.
5 Position the Mounting Brackets
RECOMMENDED SPACING
70”
8”
39”
32”
LATCH RAIL
7 Install Shorter One-Way Screw
With a 3/16’’ drill bit, use each
bracket as a template to drill a
hole into the door. Do not drill all
the way through the door. Secure
each bracket to the door with one
1/4x1’’ one-way screw.
Important: Once installed, these
screws cannot be easily removed.
1/4x1’’ ONE-WAY SCREW
QTY: 2 OR 8
8 Attach Door to the Door Frame
Hold the door to the door frame as shown in the Step 3 and re-verify
the door fits and operates properly. With a 3/16’’ drill bit, use each
bracket as a template to drill one 4’’ deep hole into the door frame.
Mount the door to the door frame with one 1/4x4’’ one-way screw per
bracket. Start with the top middle bracket.
Important: Do not drill or mount the latch rail yet.
1/4x4’’ ONE-WAY SCREW
QTY: 1 PER BRACKET
6 Attach Mounting Brackets with Self-Drilling Screw
Using a drill and a 3/8’’ socket driver,
fasten mounting brackets to the door
and latch rail using one 1/4x1’’
hex-head screw per bracket.
1/4x1’’ SELF-DRILLING HEX-HEAD
SCREW QTY: 2 OR 8
LARGE END CAP: QTY 4
SMALL END CAP: QTY 2
1/8”
DOOR
LATCH
RAIL