User's Manual

2
INSTRUCTION TO THE USER
This equipment has been tested and found to comply with the limits for a class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a typical installation. This equipment generates, uses and can
radiate radio frequency energy and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna on the device experiencing the interference
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which this device is
connected
Consult the dealer or experienced technician for the device experiencing the interference
In order to maintain compliance with FCC regulations, no changes can be made to this equipment
without the approval of Gatekeeper Systems, Inc. The user is cautioned that any changes or
modifications made to the equipment without the approval of Gatekeeper Systems, Inc. could void
the user’s authority to operate this equipment.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
IC / ISED statements:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
1 . This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
Declaration of Conformity (RED)
Hereby, we declare that the radio equipment type model D-9000A-SMT is in compliance
with Radio Equipment Directive (RED) 2014/53/EU. The relevant harmonized test
standards are listed:
ETSI EN 300 440 V2.1.1 (2017-03), EN 62368-1:2014, EN 62479: 2010
Draft ETSI EN 301 489-1 V2.2.0(2017-03), Draft ETSI EN 301 489-17 V3.2.0(2017-03)
The suggested ambient temperature is around 0°C to 40°C