User's Manual

1. PermissionManager:
The Gatekeeper Systems D-9760 PermissionManager contains two 2.4GHz transceivers
and it is used to send commands to and receive data from the Gatekeeper Systems
wheels.
2. PermissionManager detail:
Power up PermissionManager, by providing +3.3V DC power supply at connector block
pin 1 and grounding at connector block pin 4.
While power up, Green LED will be ON to indicate PermissionManager is power up. Then
the Green LED will start flashing. It indicates that the PermissionManager is in operating
mode.
Connector Block Definition:
Pin
Name
Description
1
3.3VDC
+3.3V DC, 1.5A
2
SIGNAL 1
Control the ON/OFF of antenna 1
3
SIGNAL 2
Control the ON/OFF of antenna 2
4
GND IN
Power Grounding
LED Definition:
Status
Description
Solid
Power Up
Flashing
Operating Mode
3. Installation
Mount PermissionManager on the table or on the wall flatly by two screw holes with the
bottom surface (The surface with connector block and Dip switch) facing the mounting surface
of table or wall
Screw hole
Connector Block
Green LED
DIP Switch