User's Manual
Table Of Contents
- Section 1 Introduction
- 1.1 Purpose of This Manual
- 1.2 General Description
- 1.3 General Specifications
- Section 2 Installation / Initial Turn-On
- 2.1 Introduction
- 2.2 Installation Checkboxes
- 2.3 Transmitter Cabinet Placement
- 2.4 Transmitter AC Connection
- 2.5 Signal and Ground Connections
- 2.6 Interlock Connections
- 2.7 3 Port Patch Panel
- 2.8 Motorized RF Switch Connections
- 2.9 Install PA and PS Modules
- 2.10 Initial Turn-On
- 2.11 Parallel Remote Control Connections
- 2.12 Remote Status Outputs, J15 & J16
- Section 3 Operation/ Adjustments
- 3.1 Introduction
- 3.2 Transmitter Control Panel
- 3.3 Graphical User Interface (GUI)
- 3.4 GUI Home Page
- 3.5 Drive Chain Main Menu
- 3.6 Power Amp Main Menu
- 3.7 Output Main Menu
- 3.8 Power Supply Main Menu
- 3.9 System Main Menu
- 3.10 GUI Menu Structures
- Section 4 Theory of Operation
- 4.1 Introduction
- 4.2 Block Diagram Descriptions
- 4.3 Transmitter Control System
- 4.4 Transmitter RF System
- 4.5 Power Supplies
- Section 5 Replacement Procedures
- 5.1 Introduction
- 5.2 PA Module Removal
- 5.3 PA Module Pallet Replacement
- 5.4 Power Supply Module Replacement
- 5.5 Circulator Removal/Replacement
- 5.6 Blower Assembly Removal
- Section 6 ISP (In-System Programming)
- 6.1 Introduction
- 6.2 Installing the ISP Program
- 6.3 ISP Procedures
- Section 7 Parts List
- 7.1 Parts List Index
10/19/07 888-2687-001 6-3
WARNING: Disconnect primary power prior to servicing.
Section 6 ISP (In-System Programming)
Ranger ™ Mobile Series
When firmware in the transmitter is updated, all firmware revisions (for the controllers
and the modules) should be checked and brought up to the revision levels on the CD-
ROM if not already the same. The .s19 file names for the controllers and the modules
have the revision number as part of the name.
For example: RANGER_CTRL_APP_0013.s19 is revision 1.3 Main Controller code.
6.3.1 Control System ISP Procedure
The example given here is for updating the Main Controller board since the steps are
the same for the other control boards except for the update file. This means the
procedure is to be repeated for updating each of the following control boards:
• Main Controller
• RF Monitor
• PA Monitor
• External I/O
STEP 1 Insert the CD-ROM into the disk drive.
STEP 2 Open the transmitter controller front door. Connect a standard RS-232
cable from the serial port on your computer to DB9 connector J90 on the
left edge of the Main Controller Board.
STEP 3 Run the “Harris ISP.exe” program. The window shown in Figure 6-2
should open.
STEP 4 Set “Port” to the number of the COM port being used on your computer.
STEP 5 Set “Baud” to 19200.
STEP 6 Press Query Micros; wait for system to recognize the 4 controller boards
as shown in Figure 6-3. If it does not find the micros, press Stop Query,
change the COM port and press Query Micros again.