User's Manual
Table Of Contents
- Section 1 Introduction
- 1.1 Purpose of This Manual
- 1.2 General Description
- 1.3 General Specifications
- Section 2 Installation / Initial Turn-On
- 2.1 Introduction
- 2.2 Installation Checkboxes
- 2.3 Transmitter Cabinet Placement
- 2.4 Transmitter AC Connection
- 2.5 Signal and Ground Connections
- 2.6 Interlock Connections
- 2.7 3 Port Patch Panel
- 2.8 Motorized RF Switch Connections
- 2.9 Install PA and PS Modules
- 2.10 Initial Turn-On
- 2.11 Parallel Remote Control Connections
- 2.12 Remote Status Outputs, J15 & J16
- Section 3 Operation/ Adjustments
- 3.1 Introduction
- 3.2 Transmitter Control Panel
- 3.3 Graphical User Interface (GUI)
- 3.4 GUI Home Page
- 3.5 Drive Chain Main Menu
- 3.6 Power Amp Main Menu
- 3.7 Output Main Menu
- 3.8 Power Supply Main Menu
- 3.9 System Main Menu
- 3.10 GUI Menu Structures
- Section 4 Theory of Operation
- 4.1 Introduction
- 4.2 Block Diagram Descriptions
- 4.3 Transmitter Control System
- 4.4 Transmitter RF System
- 4.5 Power Supplies
- Section 5 Replacement Procedures
- 5.1 Introduction
- 5.2 PA Module Removal
- 5.3 PA Module Pallet Replacement
- 5.4 Power Supply Module Replacement
- 5.5 Circulator Removal/Replacement
- 5.6 Blower Assembly Removal
- Section 6 ISP (In-System Programming)
- 6.1 Introduction
- 6.2 Installing the ISP Program
- 6.3 ISP Procedures
- Section 7 Parts List
- 7.1 Parts List Index
4-2 888-2687-001 10/19/07
WARNING: Disconnect primary power prior to servicing.
Ranger ™ Mobile Series
Section 4 Theory of Operation
4.3 Transmitter Control System
The Ranger Series transmitters utilize a very advanced but simple to use control system.
It is a microprocessor, serial communication based software control system but uses
backup Life Support logic circuitry and hard wired control lines, allowing the
transmitter to be on the air even if the main control system fails.
Figure 4-1 shows a simplified block diagram of the transmitter control system. The left
side of the diagram shows the external connections to the transmitter or more
specifically the External I/O Board. The right side of the diagram shows the internal
control system inter-connections from the Main Controller to the various sub-systems
inside the transmitter cabinet.
Figure 4-1 Control System Simplified Block Diagram
Serial Remote control is not available
Note: