Server User Manual

Drives 23
4
Replacing and
Adding Internal
Devices
Drives
There are several types of drives and similar devices that can be installed in
the server.
Preparing to replace or add a drive
One 3.5-inch diskette drive, at least one 1-inch high 3.5-inch hot-plug hard
drive, and one slimline CD drive are included with the server. You can add
up to three additional 3.5-inch hot-plug drives for a total of four hot-plug
drives.
As you prepare to install drives, keep the following in mind:
■ If you remove a drive, place it in an antistatic bag or container.
■ Before you install a drive, see the drive documentation for information
on configuring the drive, setting any jumpers on the drive, and attaching
cables to the drive.
■ If you are installing a drive that uses an add-in controller, install the
expansion card before you install the drive.
■ You may need to configure the drives you install using the BIOS Setup
utility or the SCSISelect utility. Press F2 at start up to open the BIOS Setup
utility or press C
TRL+A to enter the SCSISelect utility.
8506162.book Page 23 Wednesday, May 10, 2000 10:21 AM